10.75 inches long Kukri point Blank blade, hand forged Ladder pattern Damascus steel hunting knife blade, knife making supplies, 3 Pin hole scale, 6" sharp cutting edge

Blade is made of Damascus steel by forging the 1095 and 15N20 high and low carbon steel Our Damascus steel is prepared by forging over 465 layer of high carbon and low carbon steel. Blade has been given an excellent heat treatment to get it well hardened. Hardness 56 to 58 HRC. Tips to Care Damascus knife: Damascus steel as well as 1095 high carbon steel knives are different than some other common steel knives because of its high carbon content they can be rusted if not care properly. If you have seen rust accidentally then use WD40 to remove it. Never store your knife for long time in leather sheath. Leather can absorb water which will rust the knife. Always clean the blade after using and apply oil or wax (please use cooking oil on Chef Knife) before you store it, for its longer life and durability

• Overall 10.75 inches Long hand forged full tang Ladder pattern Damascus steel blank blade
• 6 inches long cutting edge. Up to standard of Kukri point blade skinning Knife
• 4.5" long Scale space with 3 Pin holes for extra strength of scale.
• Approximately 5 mm Thick Ladder pattern Damascus steel clip point blade. Our Damascus steel is prepared by forging over 465 layer of high carbon and low carbon steel.
• Blade is made of Hand forged Damascus steel by forging the 1095 and 15N20 high and low carbon steel